• November 23. 2021

The QSFP-40/100-SRBD is a dual-rate bidirectional (BiDi) optical module. It features 40G and 100G transmission rates and dual-fiber LC interface type. It can easily help customers upgrade from 10G to 40G/100G networks using existing 10G network duplex multimode fiber architecture. In the following, ETU-LINK will introduce the relevant parameters of the QSFP-40/100-SRBD optical module and the ...

• November 05. 2021

At present, MPO patch cord is widely used in high-speed and high-density data center wiring, and its quality determines the stability and sustainability of the whole data center network. So what factors should we consider when choosing MPO patch cord? Today ETU-LINK will introduce the Purchasing Guide of MPO patch cord.     1. Choose a patch cord with a small insertio...

• October 23. 2021

This blog ETU-LINK takes everyone to understand the difference between optical fiber, copper cable and twisted pair. First of all, let’s understand the twisted pair. The twisted pair is made up of multiple groups of insulated copper wires intertwined. The internal medium of the twisted-pair cable is also copper wire, and the internal transmission is an electrical signal. According to the principle...

• October 14. 2021

In this article, ETU-LINK will take everyone into the optical fiber cabling system, which is simply the transmission network in buildings and complexes. The integrated wiring system is a digital infrastructure built by intelligent offices, which can support integrated applications such as voice, data, graphics, and multimedia. The integrated optical fiber wiring system is divided into the followin...

• September 25. 2021

DWDM is a dense wavelength division technology. This technology multiplexes the tight spectral spacing of a single optical fiber carrier in a designated optical fiber in order to utilize the achievable transmission performance. This technical solution is used to increase the bandwidth of the existing laser technology on the optical fiber backbone network. The following ETU-LINK will introduce 10G ...

• September 23. 2021

Nowadays, the rapid development of data services has led to an increasing speed of IP network convergence, so network expansion is very important. In the construction of metropolitan area networks, there is a widespread problem of optical fiber shortage. Because metro expansion requires less channel numbers than trunk systems, and the distance is relatively short, optical amplification is not requ...

• September 11. 2021

The previous storage technology only uses the storage device as an auxiliary device of the server. The large-capacity data exchange between servers can only rely on traditional networks, and cannot adapt to the development of IT technology in terms of speed, security, cross-platform sharing, and unlimited expansion. Under such circumstances, SAN technology came into being. Fibre Channel SCSI techn...

• August 31. 2021

In this article, ETU-LINK will explain several problems that may occur after the optical fiber test is passed and the corresponding detailed analysis. (1) Why does the optical fiber test pass, but the packet is still lost when the network is running? In the standard selection, many users will make some obvious mistakes, such as not paying attention to whether the tested fiber is 50/125μm (OM2, OM3...