• July 29. 2022

Communication has existed since the primitive society. Beacon fires and flying pigeons were common communication methods in ancient times. Later, after the industrial revolution, telegraph and telephone appeared. Until the modern optical network, communication technology has been developing continuously. However, the three basic elements to complete the information transmission, namely the source,...

• July 14. 2022

The data shows that the growth rate of 10G and 40G ports is much higher than the low-speed growth rate. As the core technology and key part of the next-generation high-speed and large-capacity optical network, 40G optical module has high transmission rate and small size. Wide range of applications, the following ETU-LINK will introduce the next 40G optical module - 40G PSM4 optical module. &n...

• July 12. 2022

The 100G QSFP28 SR4 optical module has a wavelength of 850 nm and uses a 4-channel 850 nm VCSEL laser array and a PIN photodetector array, and each channel can run at a rate of 25Gbps. The 100G QSFP28 SR4 optical module uses an MPO interface (12 cores) and has a transmission distance of 70m when used with OM3 multimode fiber and 100m when used with OM4 Multimode fiber. The 100G QSFP28 SR...

• July 07. 2022

As the Ministry of Industry and Information Technology issued 5G commercial licenses to China Telecom, China Mobile, China Unicom and China Radio and Television. 5G network over the next five years (fifth generation) mobile communication technology rapid development will become hot spot in the field of information and communication, bearing network construction and upgrade the first push light tel...

• June 18. 2022

The PCBA board is the core control circuit of optical transceivers, including SFP, SFP+, QSFP+ and 100G modules. In this blog, ETU-LINK will introduce the electronic components of the PCBA board in the optical module.  This article focuses on the electronic components on optical module PCBA, their definitions, functions, and applications in fiber optic communication systems, helping...

• May 31. 2022

AOC active optical cable refers to the communication cable that needs to use external energy to convert electrical signals and optical signals to each other in the communication process, and the optical transceivers at both ends of the optical cable provide photoelectric conversion and optical transmission functions. Today ETU-LINK will introduce the 40G AOC active optical cable.   The 4...

• May 09. 2022

The 10G SFP+ optical transceiver is widely used in 10G Ethernet and is common in next-generation mobile networks, fixed access networks, metropolitan area networks, and data centers.The following ETU-LINK for everyone to check the next 10G SFP+ optical transceiver are what it. 10G SFP+ Duplex Optical Transceiver 10G SFP+ duplex optical transceiver is a conventional optical transceiver with two LC ...

• May 05. 2022

Optical module is the basic unit to realize photoelectric conversion in 5G network. It is widely used in wireless and transmission equipment. It is an important part of 5G construction. The capital pressure of 5G large-scale construction leads to cost sensitivity, and the cost of optical module accounts for more than 50% of 5G pre transmission equipment. The industry has carrie...